Calibration Device (VAS 6350/4), Mounting and Adjusting
Calibration Device (VAS 6350/4), Mounting and Adjusting
Special tools, testers and auxiliary items required
• Calibration tool for lane changing assist (VAS 6350)
• Vehicle diagnostic tester
The Calibration device (VAS 6350) is made up of the following components:
• Wheel center sensor (VAS 6350/1)
• Spacing laser (VAS 6350/2)
• Line Laser (VAS 6350/3)
• Calibration tool for lane changing assist (VAS 6350/4)
Installed Calibration Device (VAS 6350) Overview
1 Wheel Center Sensor (VAS 6350/1)
2 Wheel Center Sensor (VAS 6350/1)
3 Right Angle Bracket
• Spacing laser (VAS 6350/2) mount
4 Plastic Foot
• Three on the underbody of the calibration device (VAS 6350/4)
• Adjustable in order to adjust horizontal position of calibration device (VAS 6350/4)
5 Line Laser (VAS 6350/3)
• On Calibration Device (VAS 6350/4)
• Switching on and off, refer to the operating instructions.
6 Spacing Laser (VAS 6350/2)
• Notes on operation, refer to the operating instructions.
7 Spirit Level On Calibration Platform
• On Calibration Device (VAS 6350/4)
• For checking the horizontal position.
8 Left Angle Bracket
• Spacing laser (VAS 6350/2) mount
9 Calibration Tool For Lane Changing Assist (VAS 6350/4)
• Between the corners of the calibration device (VAS 6350/4) and the wheel center sensor (VAS 6350/1) - dimension A - 1.47 m to 1.90 m (5 to 6 ft.)
Map Orientation for the Calibration Device (VAS 6350/4)
- Position the calibration platform (VAS 6350/4) behind the vehicle at a distance of 1.47 m to 1.90 m (5 to 6 ft.) to the rear wheels, see - dimension A - in the illustration.
- Bring calibration tool for lane changing assist (VAS 6350/4) to a horizontal position.
- To do so, twist plastic feet under calibration tool for lane changing assist (VAS 6350/4) so that air bubble in level is located exactly in the center of the indicator - arrow -
Make sure light does not reflect off the calibration device (VAS 6350/4).
Reflections affect the rear view camera (R189) and may make it impossible to perform the calibration.
- Switch on the line laser (VAS 6350/3) - 1 - on the calibration tool for lane changing assist (VAS 6350/4) and then align the calibration tool for lane changing assist (VAS 6350/4) so that the laser beam is pointed to the center of the Audi rings.
- Make sure the Audi rings are centered on the rear. Adjust the laser beam as needed.
Continue to calibrate the rearview camera (R189)=> [ Rearview Camera (R189), Calibrating ] Rearview Camera (R189), Calibrating.