Shift Interlock Solenoid: Service and Repair

Shift Lock Solenoid

Removing

- Remove installation frame with Multimedia Control Head (E380) - 1 -.





- Disconnect electrical connector - 1 -.





- Remove selector housing insulation - 2 -.

- Remove front ashtray/front compartment.

- Remove center console bracket screws - arrows - and - 1 -.





- Disconnect electrical connector - 1 -.





- Remove four bolts - arrows -.

- Remove four bolts - arrows -.





• To provide a better illustration, shown here without center console bracket.

- Remove center console bracket by tilting selector mechanism function unit.

- Press parking lock button - C - down and hold.





- Place selector lever in position "S".

- Disconnect electrical connector - 1 - at Shift Lock Solenoid (N110).





• When removing magnets, lift them forward slightly so that ball head - 2 - disengages from operating lever - 1 -.





• Shown with selector mechanism removed to provide a better illustration.

- Release catches - arrow A - and remove Shift Lock Solenoid (N110) forward - arrow B -.





Installing

• Selector lever in "S" position.

- Unclip emergency release lever in direction of - arrow - at sides.





- Pull manual release lever - arrow - upward.





• When manual release lever is raised, Shift Lock Solenoid (N110) operating lever - 1 - swings into installation position.





- At the same time, position Shift Lock Solenoid (N110) at an angle in guide from above.

- Press Shift Lock Solenoid (N110) into guide until it engages.

• Shift Lock Solenoid (N110) ball head - 2 - must engage in operating lever on selector mechanism.

- Connect connector - 1 -.





Perform function check on Shift Lock Solenoid (N110) before completing assembly.

- Connect connector - 1 -.





- Connect connector - 1 -.





- Before completing assembly, check function of Shift Lock Solenoid (N110) in "P" and "N" positions, => [ Selector mechanism function
test ] Testing and Inspection

Further installation is done in reverse order of removal, similar to installation of selector mechanism function unit => [ Selector Mechanism Unit ] Selector Mechanism Unit.