Right Flange Shaft Needle Bearing

Right Flange Shaft Needle Bearing

Special tools, testers and auxiliary items required

• Thrust Plate (VW 401)

• Thrust Plate (VW 402)

• Punch (VW 407)

• Thrust Disc (VW 412)

• Alignment Fixture (VAS 3253)

• Assembly Tool (T10047)

Procedure

- Remove right flange shaft. Refer to => [ Right Flange Shaft ] Right Flange Shaft.

- Mount the (T10047) as illustrated.





• The markings B on both parts face each other

• The sections - arrows - must then be located under the bearing.

- Bolt the parts together.

- Remove the circlip - A -.





- Shaft must be rotated while pressing off - arrow - so that the needle bearing contact surface on shaft is not damaged.

- Shaft must be rotated while pressing on - arrow - so that the needle bearing contact surface on shaft is not damaged.





- Secure the needle bearing with a new circlip.

- Install right flange shaft. Refer to => [ Right Flange Shaft ] Right Flange Shaft.