Harmonic Balancer - Crankshaft Pulley: Service and Repair

Vibration Damper

Special tools, testers and auxiliary items required

• Locking Pin (T10060 A)

• Counter-Holder Tool (T10069)

Removing

• Before removing the ribbed belt, mark the turning direction on it with chalk or a felt tip pen. A reversed direction of rotation can cause damage to the belt under operating conditions.

- Swing tensioning device in direction of - arrow - to relieve tension on the ribbed belt and then lock it in place using the (T10060 A).





- Remove center noise insulation fasteners - 1 to 3 -.





- Remove right noise insulation fasteners - 1 to 3 -.





- Remove the ribbed belt from the vibration damper belt drive pulley.

- Remove bolt from vibration damper, thereby using (T10069) to counter-hold.





Installing

• Tightening specifications, refer to => [ Ribbed Belt Drive Component Overview ] Ribbed Belt Drive Component Overview

Installation is in reverse order of removal, note the following:

- Use new bolt to fasten.

- To fasten the bolt for vibration damper, counter-hold with (T10069).

- Install ribbed belt. Refer to => [ Ribbed Belt ] Ribbed Belt.