Intake Manifold Upper Section Component Overview

Intake Manifold Upper Section Component Overview





1 Intake Manifold Tuning Valve Position Sensor ( G513)

2 2.5 Nm

3 2.5 Nm

4 Actuator for Intake Manifold Change-Over

• Installed location of tooth segments for variable intake manifold,

• As replacement part together with - 24 -

5 Seal

• Replace if damaged

• Lift out with screwdriver to replace

• Press in by hand

6 Ball Pin - 2.5 Nm

7 Intake Manifold Upper Section

• Removing and installing, refer to => [ Intake Manifold Upper Section ] Intake Manifold Upper Section.

8 Throttle Valve Control Module (J338)

9 5 Nm

10 Wire Harness Retainer

11 Seal

• Replace

12 Intake Manifold Runner Control Valve (N316)

13 2.5 Nm

14 Intake Air Temperature Sensor (G42)/Manifold Absolute Pressure Sensor (G71)

15 O-Ring

• Replace

16 2.5 Nm

17 Crankcase Housing Ventilation Pressure Regulator Valve

18 O-Ring

• Replace

19 6 Nm

20 Washer

21 Sleeve

22 Seals

• Replace

23 Seal

• Replace if damaged

• Lift out with screwdriver to replace

• Press in by hand

24 Lever with Tooth Segment

• For variable intake manifold

• Installed location of tooth segments,

• As replacement part together with - 4 -

25 Seal

• Replace if damaged

• Lift out with screwdriver to replace

• Press in by hand

26 Change-Over Valve for Intake Manifold Flap ( N239)

Component Location of Tooth Segments for Variable Intake Manifold





• The lower edges of the tooth segments must be flush with one another - arrows -.