Part 5

Mobility Connection Package, C70



































































INTRODUCTION
- Read through all of the instructions before starting installation.
- Notifications and warning texts are for your safety and to minimize the risk of something breaking during installation.
- Ensure that all tools stated in the instructions are available before starting installation.
- Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.
- In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.






Mobility Connection Package




- Pull the cable down along the A-pillar to the dashboard.
- Cut off two 100x50 mm (4x2") pieces of foam tape in the middle.
- Secure the cable to the A-pillar using foam tape.





- Reinstall the A-pillar panel.





- Reinstall the sealing strip and ensure that it ends up on the outside of the panel.





- Secure the microphone using a small cable tie.





- Take the cable harness and control module from the kit. Connect the cable harness to the control module (1).
- Lock the catch (2).





- Take a piece of foam tape from the kit and attach it to the front of the control module.
- Fold up the foam tape around the corner and the edges on the control module.





- Get three small pieces of foam tape from the kit and fasten these on the back of the control module.





- Detach the front sill molding by first pulling it backwards at the front edge, then straight up so that the clips release.





- Unscrew the clips holding the floor carpet.
- Fold aside the floor mat to access the bulkhead panel inside.

Note! Take care not to create folds in the carpet.





- Place the control module with the thick foam tape forward, against the bulkhead.





- Fold aside the cable harnesses (1) so that they do not end up between the control module and floor mat.
- Route the control module's cable harness under the cable harnesses (2) and on toward the tunnel console.
- Fold back the carpet.





- Connect the connectors for the Bluetooth system as illustrated:
1. cable harness power supply
2. the microphone
3. the control panel
- Take one of the cut pieces of foam tape and tape around the connectors.





- Place the connectors and the excess wiring inside the center console.
- Fold back the carpet.





- Take two large tie straps from the kit and secure the cable from the microphone on top of the collision pipe.
Applies to cars with external amplifier
- Also secure the cable harness B, that is to be later routed back to the external amplifier.





- Reinstall the connectors to the rear section of the glove box. Note the color marking on the cable for the right-hand connector.

Reinstall:




- the lower vent.
- the sound proofing.
- the rear section of the glovebox by guiding it in diagonally inside the centre console and then straight forward. The rear section must be positioned on the outside of the remaining inner section.
- the clip for the vent on the glovebox.
- the panel on the dashboard end face.
- Remove the tape
- the panel above the centre console. Check that the cable to the control panel is not pinched.
- the sill trim panels.
- cushion





- Download the software for the accessory's function following the service information in VIDA.





Check the function of the Bluetooth system as follows:
- Turn the ignition key to position I.
- Turn the radio on. Wait 20 seconds.
- Check that the control panel for Bluetooth illuminates. Press the round button (1) in the middle of the control panel. The radio should then mute and a voice should be heard.
- Press the red handset button (2). The voice should now stop and the audio from the radio returns.