Part 3

Parking assistance, rear, chassis number 97000-

INTRODUCTION
- Read through all of the instructions before starting installation.
- Notifications and warning texts are for your safety and to minimize the risk of something breaking during installation.
- Ensure that all tools stated in the instructions are available before starting installation.
- Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.
- In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Parking assistance, rear, chassis number 97000-

Applies to cars with keyless systems
- Connect and reinstall the aerial.

Applies to cars without keyless systems
- Secure the loose connector using butyl tape to prevent rattling.

Applies to all models

- Install the spacers on the two studs.

- Place the control module on the spacers and the studs.

Connect:
- the brown 12-pin connector to the control module's top connection.
- the black 16-pin connector to the control module's lower connection.

- Connect the green 5-pin connector to the green connector that is taped to the car's usual cable harness.
- Connect the grey 2-pin connector to the corresponding grey connector.
- Secure the clip of the cable harness to the panel edge.

Applies to cars with a trailer module (TRM)

- The car's usual green connector is connected to the TRM. Disconnect this connector.
- Connect the removed connector to the taped connector on the cable harness for PAM.
- Connect the other connector from the cable harness for PAM to the TRM.

Note! It is important that the Parking Assistance Module (PAM) is connected as the first module and that the cable harnesses are connected correctly, and not in a loop.

Applies to cars with an accessory electronic module (AEM)

- The car's usual green connector is connected to the cable harness for the AEM. Disconnect this connector.
- Connect the removed connector to the taped connector on the cable harness for PAM.
- Connect the other connector from the cable harness for PAM to the cable harness for AEM.

Note! It is important that the Parking Assistance Module (PAM) is connected as the first module and that the cable harnesses are connected correctly, and not in a loop.

Note! Prepare and install one cradle at a time.

- Use: 1161347 Tape.