Part 2

Parking assistance, rear, chassis number 97000-







































INTRODUCTION
- Read through all of the instructions before starting installation.
- Notifications and warning texts are for your safety and to minimize the risk of something breaking during installation.
- Ensure that all tools stated in the instructions are available before starting installation.
- Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.
- In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.






Parking assistance, rear, chassis number 97000-

Remove:
- the toolbox cover.
- the spare wheel, if present.






Remove:
- the tools from the tool box
- the clip
- the screw
- the toolbox.





- Remove the three screws and the load retaining eyelets from the floor.





- Remove the cover from the boot lid stop. Use a weatherstrip tool to pry between the cover and the stop to release the catches.





- Remove the two light bulbs by pressing in the two catches at the top with a screwdriver.

Applies to cars with emergency opening handle in the cargo compartment




- Remove the emergency opening handle by pressing out the pin at the eye and unhook the wire.





- Remove the two screws in the sill moulding.





- Remove the sill moulding by pulling it up until the clips release.
- Fold the sill moulding aside.





- Remove the carpet in the cargo compartment.





- Remove the rubber stop on the roof's stop brace.





- Mark out the stop bracket for the roof in relation to the screw.
- Remove the screw and the roof's stop bracket.





- Remove the load divider lock by using a weatherstrip tool to pry between the carpet and lock.
- If performing the operation on the left side, unplug the connector.





- Remove the screw and the load retaining eyelet on the right-hand side.





- Remove the stop brace cover.





- Mark out the stop braces for the roof in relation to the screws and nuts on the right side.
- Remove the screw, nut and the roof's stop braces.





- Loosen the four clips on the right side panel.





- Remove the side panel by unhooking it from the stop lug at the front edge and the pulling outward and upward so that it releases from the sealing strip.

Applies to cars with keyless locking systems




- Disconnect the 2-pin grey connector.

Applies to cars with keyless locking systems






Applies to cars with keyless locking systems




- Disconnect the cable harness retaining clips.
- Disconnect the cable harness with rubber grommet.

Applies to cars with keyless locking systems




- Remove the Keyless system aerial by pushing it up.
- Remove the connector on the antenna by pulling out the red catch and pressing in the other catch.
- Remove the cable harness. It shall not be re-used.

Applies to cars without keyless locking systems




- Remove the rubber plug.

Applies to all models




- Fasten the cable harness.
- Route the connectors into the cargo compartment and install the rubber grommet.






Applies to all models
- Fasten the cable harness.