Procedures

Tilt sensor for the alarm


















INTRODUCTION
- NOTE! Read through the whole installation instruction before starting the work.
- Cut out the text page in order to follow the illustrations and text at the same time.






Tilt sensor for the alarm

Note! This accessory requires software unique to the car.





- Fold the rear centre floor hatch up.





- Remove the left-hand side floor hatch (1).





- Remove the left-hand folding side panel.





- Disconnect the pre-routed green connector, taped on the cable harness under the fuse holder
- Connect the connector to the tilt sensor
- Install the tilt sensor on the fuse holder bracket. First hook the tilt sensor in the uppermost hole on the bracket. Then secure in the lower hole
- Reinstall the side panel
- Reinstall the side floor hatch and fold down the floor hatch.

- Program the software.