Engine, Installing

Engine, installing

Operation number: 21004-0

Note! Some variation in the illustrations may occur, but the essential information is always correct.

Installation

Caution! Make sure that no components catch when lifting the engine.

Use: Lift table.
Make sure that the mating surfaces on the ball joints and control arms are clean.
Raise the engine/transmission unit. Stop the lift approx. 15 cm before the subframe reaches the frame members.
Install (on both sides) the drive shaft to the hub.
Continue raising the engine until it is only approx. 50 mm before it makes contact.
Guide the lower steering shaft into the hole in the firewall.

the subframe. Refer to Specifications, B6324S Tightening Torque

999 5666 Wrench 999 5666 Wrench

999 7076 Lever 999 7076 Lever

Nut, ball joint. Refer to Specifications, B6324S Tightening Torque

Anti-roll bar link. Refer to Specifications, B6324S Tightening Torque

Ball joint. Refer to Specifications, B6324S Tightening Torque

Drive shaft screw. Refer to Specifications, B6324S Tightening Torque

M10. Refer to Specifications, B6324S Tightening Torque

Steering shaft joint. Refer to Specifications, B6324S Tightening Torque

M8. Refer to Specifications, B6324S Tightening Torque

M6. Refer to Specifications, B6324S Tightening Torque

Install the following items:
- M10. Refer to Specifications, B6324S Tightening Torque
- M12. Refer to Specifications, B6324S Tightening Torque

Install the following items:
- the auxiliaries belt. Refer to: Service and Repair
- the catalytic converter. Refer to: Catalytic converter, B6324S Service and Repair
- the propeller shaft. Refer to: Propeller Shaft, B6324S, TF-80SC AWD Propeller Shaft
- front tires. Refer to: Installing wheels Service and Repair

Charge the cooling system. Refer to: Cooling system - draining, charging and bleeding Service and Repair
Connect the battery. Refer to: Battery, replacing Removal and Replacement

Move over the oil level sensor. Refer to: Level sensor engine oil, B6324S Service and Repair