Fault-Tracing

Fault tracing ECM-P252B00

Checking components and wiring








- Ignition off
Check the oil level sensor connector for contact resistance and oxidation.
Disconnect the engine control module (ECM).
Check the power cable for open-circuit. Measure between control module terminal #A47 (#A47) and oil level sensor terminal #3.
Check the signal cable for open-circuit. Measure between control module terminal #A63 (#B3) and oil level sensor terminal #1.
Remedy as necessary.

Other information
- Connecting the breakout box, B8444S Connecting the Breakout Box
- Oil level sensor, replacing Service and Repair
- Checking wiring and terminals Checking Wiring and Terminals









Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reconnect the connectors, components, etc.
- Start the engine.
- Read the diagnostic status and fault status for the diagnostic trouble code by selecting the diagnostic trouble code in the list.
Increase the engine speed a few times until the scan is "Implemented".
Check the fault status for the diagnostic trouble code when the scan is "Implemented". When the function is correct the fault status should be "No fault found" when the scan is implemented.





Is the function OK?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking components and wiring

-------------------------------------------------