Troubleshooting

Troubleshooting ECM-P061500

Checking components and wiring








- Ignition off
Disconnect the engine control module (ECM).
Check the signal cables for start relay for open circuit to ground.
Measure between:
- Control module #B11 (#C11) and start relay.
- Control module #B51 (#C51) and start relay.
Remedy as necessary.

Other information
- Connecting the breakout box, B8444S Connecting the Breakout Box
- Component specifications, B8444S [1][2]Computers and Control Systems
- Checking wiring and terminals Checking Wiring and Terminals





Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reconnect the connectors, components, etc.
- Run the starter motor/start the engine.
- Allow the engine to idle if it starts.
- Read the diagnostic status and fault status for the diagnostic trouble code by selecting the diagnostic trouble code in the list.
Check the fault status for the diagnostic trouble code when the scan is "Implemented". When the function is correct the fault status should be "No fault found" when the scan is implemented.





Is the function OK?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking components and wiring

-------------------------------------------------