Checking Components

Checking Components







CAUTION: Do not apply rust solvent spray or grease to the heated oxygen sensor's (HO2S) connector.

Check the cable between the Engine Control Module (ECM) terminal #A41 (#A41) and heated oxygen sensor terminal #4 (bank 1). Check for a short-circuit to supply voltage.

If the above troubleshooting does not solve the problem, try a new heated oxygen sensor.

Remedy as necessary.

Other Information
- Connecting the breakout box
- Signal specification, engine control module (ECM)
- Heated oxygen sensor (HO2S), replacing
- Checking wiring and terminals

Continue: Refer to Verification. Verification