Checking Components

Checking Components







CAUTION: Do not apply rust solvent spray or grease to the heated oxygen sensor (HO2S) connector.

Check the cable between rear heated oxygen sensor terminal #1 (bank 1) and voltage supply from the system relay. Check for a short-circuit to supply voltage.

Try a new rear heated oxygen sensor if the above measure does not remedy the fault.

Remedy as necessary.

Other Information
- Connecting the breakout box
- Signal specification, engine control module (ECM)
- Heated oxygen sensor (HO2S), replacing
- Checking wiring and terminals

Continue: Refer to Verification. Verification