Signal Too Low
Signal too low
Checking the component
Check that the fuse for the intermittent relay, windshield wipers is intact.
Replace relay 2/91.
Activate the relay for windshield wipers on.
If the function is OK the cause of the fault was a damaged relay (open-circuit in the relay).
Other information:
- For further information about fuses and relays, see the relevant wiring diagram.
- For information about fuse and terminal numbers, see the relevant Wiring Diagram.
Was the function OK?
Yes - Verification
No - Checking fusebox
-------------------------------------------------
Checking fusebox
Remove windshield wiper relay 2/91 from the fusebox base.
Check the relay base terminals. Check for contact resistance and oxidation.
Check the cable between relay base 2/91 terminal #2 and central electronic module (CEM) terminal #C4 (4). Check for an open-circuit.
Reinstall and activate the relay.
Remedy as necessary.
Other information
- For further information about fuses and relays, see the relevant wiring diagram
- Checking wiring and terminals Checking Wiring and Terminals
Was the function OK?
Yes - Verification
No - Checking the wiring
-------------------------------------------------
Verification
Verification
Hint: After carrying out the repair, check that the fault has been remedied.
- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Activate the windshield wipers.
Check that the windshield wipers work in all positions.
Are the windshield wipers working?
Yes - Troubleshooting procedure complete
No - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
Do you want to exit fault-tracing?
Yes - Exit Fault-tracing
No - Attempt New Test
------------------------
Attempt New Test - Checking fusebox
-------------------------------------------------
Checking the wiring
Remove windshield wiper relay 2/91 from the fusebox base.
Check the cable between relay base terminal #2 and ground. Check for a short-circuit to ground.
Remedy as necessary.
Replace the fusebox if no fault is found.
Other information
- For further information about fuses and relays, see the relevant wiring diagram
- Checking wiring and terminals Checking Wiring and Terminals
Continue - Verification
-------------------------------------------------