Troubleshooting

Troubleshooting BCM-C111542

Checking the diagnostic trouble codes (DTCs)








- Ignition off
- Check the connector of the brake control module (BCM) for contact resistance and oxidation.
- Reinstall the components, reconnect the connectors etc.
- Ignition on
- Wait approximately 60 seconds.
- Read the status of the diagnostic trouble code.
If the diagnostic trouble code status is permanent, replace the brake control module (BCM).

Other information
- To access brake control module (BCM) connectors: Connecting the breakout box, brake control module (BCM), B8444S, B6324S Connecting the Breakout Box
- Brake Control Module (BCM), replacing Service and Repair
- Checking wiring and terminals Checking Wiring and Terminals





Was the status of the diagnostic trouble code permanent?

Yes - FAULT FOUND

No - Troubleshooting information

-------------------------------------------------

Troubleshooting information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Exit Fault-Tracing

------------------------

Attempt New Test - Checking the diagnostic trouble codes (DTCs)

-------------------------------------------------