Fault-Tracing

Fault-tracing ECM-P010600

Checking the connectors and hose connector
Check the hose connectors on the intake manifold for damage and leakage.
Check the connector and terminals on the pressure sensor. Check for contact resistance. Check for oxidation.
Remedy as necessary.

Other information
- Manifold absolute pressure (MAP) sensor, replacing, B8444S Service and Repair
- Checking wiring and terminals Checking Wiring and Terminals








Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on
Read off the pressure sensor signal for intake pressure and the atmospheric pressure sensor signal by clicking on the VCT2000 symbol.
Check that the values correspond. The atmospheric pressure sensor signal is used as a reference value in this check.





Is the value within its permitted range?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

VERIFIED - DONE

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-tracing

No - Attempt New Test

-------------------------------------------------