Checking Components and Wiring

Checking Components And Wiring







- Ignition off

The diagnostic trouble code (DTC) is stored if there is no communication between the engine control module (ECM) and the alternator control module (ACM). This may be due to a fault in the signal cable between the control modules or a damaged communication device in one or all of the control modules.

HINT: This diagnostic trouble code (DTC) can be stored if a generator (GEN) with a charge regulator not intended for LIN communication is installed.

Check the connector on the alternator control module (ACM). Check for contact resistance and oxidation.

Check the signal cable for open circuit, short circuit to ground and short circuit to supply voltage.

Take readings between engine control module (ECM) terminal #A25 (A#25) and the alternator control module (ACM).

Remedy as necessary.

Other Information
- Connecting the breakout box
- Signal specification, engine control module (ECM)
- Checking wiring and terminals

Continue: Refer to Verification. Verification