Verification

Verification







HINT: After carrying out the repair, check that the fault has been remedied.

- Ignition off
- Reconnect the connectors, components, etc.
- Start the engine.
- Test drive the car on the road with smooth acceleration so that the engine speed (rpm) exceeds 3500 rpm. Repeat the procedure a couple of times so that the engine control module (ECM) can carry out diagnostics.
- Connect VCT2000 to the data link connector without switching off the engine.
- Read the diagnostic status and fault status for the diagnostic trouble code by selecting the diagnostic trouble code in the list.

NOTE: If the engine is switched off, the stored fault status will be erased and the test drive will have to be repeated.

Check the fault status for the diagnostic trouble code when the scan is "Implemented". When the function is correct the fault status should be "No fault found" when the scan is implemented.

Is the function OK?

YES: Refer to Trouble Code Descriptions. Diagnostic Trouble Code Descriptions
NO: Refer to Fault-tracing Information - Permanent Fault.