Checking the Status

Checking The Status







- Start the engine.

Read the diagnostic status and fault status for the diagnostic trouble code by selecting the diagnostic trouble code in the list.

Increase the engine speed a few times until the scan is "Implemented".

Check whether the fault is permanent or intermittent. Read off the diagnostic trouble code (DTC) fault status when the diagnostic status is "Completed".

The fault is permanent if the fault status is "Fault found". If the fault status is "No fault found" the fault is intermittent and not presently active.

NOTE: The fault status cannot change from "Fault found" to "No fault found" in the same operating cycle.

Continue: Refer to Checking Components and Wiring. Checking Components and Wiring