Verification
Verification
HINT: After repairing, it is necessary to check that the malfunction has been fixed.
- Test-drive the vehicle on road and make sure that a fuel shut-off is performed. Easiest to do this by driving approx. 80 km/h and suddenly release the accelerator pedal for at least 5 seconds.
- Connect VCT2000 to the data link connector without turning off the engine.
NOTE: If the engine is turned off, the stored trouble status will be erased and the test-drive will have to be repeated.
Read off the diagnostic status and trouble status for the diagnostic trouble code.
Check that the diagnosis is "Implemented" and that the trouble status is "No malfunction found". If the trouble status is "Malfunction found", this indicates defective function.
Trouble status shows "No malfunction found"?
YES: Refer to Trouble Code Descriptions. Diagnostic Trouble Code Descriptions
NO: Refer to Fault-Tracing Information - Permanent Fault.