Electric Motor Backrest Cushion, Replacing

Electric motor backrest cushion, replacing

Note! Since the illustrations in this service information are used for different model years and / or models, some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Removing the electric motor for the backrest cushion
Remove the front seat. See: Front seat, replacing Front Seat, Replacing.
Detach and pull up the upholstery. See: Upholstery back rest, replacing Upholstery Back Rest, Replacing.




Remove the black protective pad from the reverse of the backrest cushion. It is secured by 4 clips.




Cut off the 4 x half moon clips on the foam rubber cushion. Fold the cushion to one side.





Remove:
- the M6 nut on the side where the electric motor is located. Pull out the shaft
- the screw for the electric motor
- the connector by pushing it backwards.

New version back motor




Carry out splicing of wire. Refer to: Connector electric motor backrest angle Procedures

Installation

Note! For tightening torques, see: Tightening torque [1][2]Body and Frame.

Install the electric motor
Insert the shaft and hang the motor on it.

Install:
- the connector
- the screw
- 1 x M6 nut
- the backrest cushion
- the 4 x half moon clips
- the protective pad
- upholstery according to: Upholstery back rest, replacing Upholstery Back Rest, Replacing
- the front seat as described in Front seat, replacing Front Seat, Replacing.