Side Panel and Control Panel Power Seat, Replacing

Side Panel And Control Panel Power Seat, Replacing

NOTE: The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removing The Side Panel







Remove:
- the cover on the side by pressing in the locking tab at the upper edge. Pull the cover upwards and out
- the mounting for the seat belt
- the mounting screw
- the panel by lifting it at the rear edge and then pushing it forwards.

Disconnect the panel connectors under the seat and disconnect the cable harness.

Removing The Control Panel







Remove:
- the 4 screws
- the control panel.

Installing The Control Panel







Install:
- the control panel
- the 4 screws.

Installing The Side Panel







Reconnect the panel connectors under the seat.

Secure the cable harness in the base of the seat.

Hook on the panel at the front edge and twist it into place.

Install:
- the mounting screw
- the seat belt. Tighten to 48 Nm
- the cover.