Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information

IMM-225 Key codes

Condition




When a key is programmed for an immobilizer control module which is already initiated, the control module verifies that the key has been correctly programmed. If not, diagnostic trouble code (DTC) IMM-225 is stored. At least one key code must be programmed into the immobilizer control module to store a diagnostic trouble code (DTC). Faults which cause diagnostic trouble code (DTC) IMM-225 to be stored can also cause diagnostic trouble codes (DTCs) IMM-233, IMM-234 or IMM-235 to be stored.
The diagnostic trouble codes (DTCs) are erased when the counter value is five.

Possible source
- Open-circuit in the wiring between control module #9 or #10 and the antenna ring.
- Short-circuit to ground in the wiring between control module #9 or #10 and the antenna ring.
- Short-circuit to supply voltage in the wiring between control module #9 or #10 and the antenna ring.
- Ignition key with defective transponder.
- Incorrect ignition key type, i.e. ignition key without transponder.
- EMC interference (strong electrical fields) disrupt communication between the immobilizer control module and the transponder.
- The ignition key is already programmed to another immobilizer control module.

Fault symptom[s]
- The indicator lamp in the combined instrument panel flashes.
- The engine does not start. (The starter motor does not operate).