Faulty Signal. Intermittent Fault

Faulty signal. Intermittent fault

Checking the connectors and camshaft adjustment




- Ignition off
- Check the camshaft position (CMP) sensor and the control module connectors. Check for contact resistance and oxidation according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults
- Check the setting of the camshafts. See Camshaft seals, replacing Removal and Replacement
- Remedy as necessary.

Other information:
- To access the control module, see Engine control module (ECM), replacing Service and Repair
- To access the camshaft position (CMP) sensor connector, see Replacing camshaft position (CMP) sensor Service and Repair.





Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking the connectors and camshaft adjustment

FAULT FOUND - DONE

-------------------------------------------------