Signal Too High. Intermittent Fault

Signal too high. Intermittent fault

Checking wiring and connectors




- Ignition off
Check the connector for the affected injector. Check for loose connections according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults. Check for contact resistance and oxidation according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Check the signal cable between the affected injector terminal #2 and engine control module (ECM) terminal #59 (ECM-1E), terminal #90 (ECM-1F), terminal #60 (ECM-20) or terminal #89 (ECM-21). Check for an intermittent short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Remedy as necessary.

Other information
- To connect the breakout box, see Connecting the breakout box. EMS 2000 Connecting The Breakout Box. EMS 2000
- For information about signals, see Signal specification Signal Specification
- To access or replace the injector, see Replacing the injector(s) Service and Repair.













Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking wiring and connectors

FAULT FOUND - DONE

-------------------------------------------------