Signal Too Low

Signal too low

Checking components, wiring and clutch pedal sensor resistance
Check the resistance of the clutch pedal sensor between terminals #2 and #4.
Check the signal cable between clutch pedal sensor terminal #2 and engine control module (ECM) terminal #B15 (#B25). Check for a short-circuit to ground.
Check the signal cable between clutch pedal sensor terminal #4 and engine control module (ECM) terminal #B4 (#B14). Check for a short-circuit to ground.
Remedy as necessary.

Other information:
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box.
- For information about the resistance of the clutch pedal sensor, see Clutch pedal sensor .
- For information about signals, see Signal specification Signal Description / Specification.
- To access and replace the clutch pedal position sensor, see Pedal position sensor clutch, replacing .
- To fault-trace the wiring and terminals, see Checking wiring and terminals Checking Wiring And Terminals.






Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on
Activate reading off the clutch position sensor value.
Depress the clutch. Check that the value changes.





Does the value change?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-Tracing Information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.

Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

YES: Troubleshooting is complete for this DTC
NO: Repeat Procedure.

-------------------------------------------------