Gear Selector Assembly

Gear selector assembly

Special tools:
999 7071 Puller 999 7071 Puller

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Preparatory work

Removing the center console
Remove center console. Floor Console

Removal

Removing gear selector knob and boot
Remove the gear selector lever knob and the boot. Knob, Gear Selector Lever

Removing the gear selector assembly




Disconnect the left-hand gear selector cable from the end of the gear selector assembly. The screw underneath is now accessible.





Caution! Make sure that there are no sharp bends or kinks in the gear selector cables.

Remove the 4 screws. Raise the gear selector assembly slightly.

Removing the transmission cables





Hint: The screw on the puller is turned counter-clockwise to pull the gear selector cable loose.

Remove the gear selector cables from the ball connectors. Use: 999 7071 Puller 999 7071 Puller.
Disconnect the gear selector cables from the end of the gear selector assembly.

Installation

Note! For tightening torques, see Specifications. [1][2]Manual Transmission/Transaxle

Installing the gear selector cables





Install by hand:
- right-hand gear selector cable in the end of the gear selector assembly
- the ball joints for the gear selector cables.

Installing the gear selector assembly





Install:
- the gear selector assembly
- the 4 M8 screws.

Installing the gear selector cables




Install the left-hand gear selector cable in the end of the gear selector assembly.

Installing boot and gear selector lever knob
Install the boot and the gear selector lever knob. Knob, Gear Selector Lever

Installing the center console
Install the center console. Floor Console