Engine Block, Installing Components

Engine block, installing components

Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However, the essential information in the illustrations is always correct.

Installation

Information




The ignition coils' direction and the routing of the cables are shown in the figure.

Installing parts on engine block





Install:
- the alternator, alternator bracket and auxiliary unit bracket
- the thermostat housing with coolant hose
- the oil filter housing
- the knock sensors
- the ignition coils
- the camshaft sensor
- the oil filler cap and the VVT-unit's control valve
- the crankcase ventilation hose
- cable harness engine, complete
- the upper and lower intake pipe
- the dipstick tube

Installing parts on engine block, continued





Install:
- the oil cooler and the rubber seals
- the coolant pipe (inlet water pump), including hoses, parted at the hoses to the oil cooler
- the bearing carrier for the right drive shaft
- the heat shield plate and exhaust manifold
- the upper and front timing gear casing
Fill oil.

Installing the flywheel and carrier plate

Install:
- the flywheel according to: Flywheel Service and Repair
- the carrier plate according to: Carrier plate Service and Repair