Rear Wheel Sensor

Replacing The Rear Wheel Sensors

Preparations
Switch off the ignition.
Remove the wheel hub.

Removing rear wheel sensor

NOTE: Clean the sensor and the switch thoroughly before removal.







- Remove the protective cover over the switch
- Separate the connector
- Remove the sensor cable from the supports
- Remove the 2 screws for the sensor
- Remove the sensor and the sensor cable.

Installing the rear wheel sensor
- Clean off all dirt and rust from the sensor seat so that the sensor is correctly positioned in relation to the pulse wheel. Clean the pulse wheel using a soft brush
- Grease the sensor lightly
- Route the sensor cable through and install the sensor
- Tighten to 55 Nm
- Press the sensor lead into place in the support
- Connect the connector
- Install the protective cover.
Install the wheel hub, brake caliper and wheel.

Final check
- Read off and erase any diagnostic trouble codes (DTCs)
- Test drive the car
- Check whether any diagnostic trouble codes (DTCs) have been stored. Read off any stored DTCs.