Power Seat Base, Replacing

Power Seat Base, Replacing

NOTE: The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removing The Base







Remove the front seat.

Disconnect the connectors and the cable harnesses mounted in the base.

Remove:
- the front screws
- the rear screws
- the base.

Installing The Base







Transfer components if necessary.

Set the seat to its highest position.

Install:
- the base
- the rear screws. Tighten by hand
- the 4 front screws. Tighten to 15 Nm
- the cable harnesses and connectors
- the front seat.