Signal Too Low. Intermittent Fault

Signal too low. Intermittent fault

Checking the cable








- Ignition off
- Disconnect the battery negative lead
- Disconnect the seat belt buckle connector
- Disconnect the SRS control module.
- Connect the battery negative lead.

Warning! There must not be anyone inside the passenger compartment when the battery is connected.

Check the seat belt buckle connector. Check for an intermittent short-circuit to ground according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Measure the resistance between the seat belt buckle connector:
- terminal #1 and chassis ground
- terminal #2 and chassis ground.
Measure between SRS control module:
- terminal #73 (#48) and chassis ground
- terminal #70 (#45) and chassis ground.
for an intermittent short-circuit to ground according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
The resistance must be infinite.
Remedy as necessary.

Other information
- To access and replace the control module see SRS control module Removal and Replacement
- To access and replace the seat belt buckle, see Seat belt buckle Seat Belt Buckle
- To connect the breakout box, see Connecting the breakout box Connecting The Breakout Box
- For information about signals, see Signal specification Signal Description. Supplementary Restraint System (SRS).









Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking the cable

-------------------------------------------------