Faulty Signal. Intermittent Fault

Faulty signal. Intermittent fault

Checking wiring and terminals
Check combined instrument panel connector B and the control module connector. Check for contact resistance and oxidation. See Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Check the cable between combined instrument connector B terminal 22 and control module terminal #16. Check for an open-circuit. See Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults. Check for an intermittent short-circuit to ground. See Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults. Check for an intermittent short-circuit to supply voltage. See Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.













Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking wiring and terminals

-------------------------------------------------