Verification - II

Verification







HINT: After carrying out the repair, check that the fault has been remedied as follows:
- Ignition off.
- Disconnect the control module.
- Vacuum pump connected.
- Ignition on.

Connect the single cable between control module connector terminals 11 and 1.

Connect the other cable with the twinned blade terminal to control module connector terminal 10.

Connect both cable ends to terminals 12 and 9.

The vacuum pump should start and the vacuum servo should compress. Remove the cable from terminal 9 when the vacuum servo is fully depressed.

Check that the vacuum servo has not released the throttle mechanism at all after one minute.

Did the vacuum pump start?

YES: Refer to Trouble Code Descriptions. Diagnostic Trouble Code Descriptions
NO: See Fault-Tracing Information - Permanent Fault. Fault-Tracing Information - Permanent Fault