Solenoid Shifting 2-3, Replacing

Solenoid shifting 2-3, replacing

Removing the side cover from the transmission
See Side cover transmission, removing Side Cover Transmission, Removing.

Removing solenoid S2





Remove:
- the connector
- the spring clamp by pulling it straight out. Use a small screwdriver
- the solenoid. Use a screwdriver between the solenoid and the housing. Carefully pry and pull the solenoid at the same time.
Check that the O-ring remains on the solenoid

Installing solenoid S2




Apply a little petroleum jelly to the solenoid O-ring.

Install:
- the solenoid by pressing it. Guide the solenoid in so that the locating pin on the side locates in the cut-out
- the spring clamp (check that it is locked)
- the connector.

Installing the side cover on the transmission
See Side cover transmission, installing Side Cover Transmission, Installing.