Checking The Key Lock

Checking the key lock

Checking the key lock




- Ignition off
- Gear selector in position P.
It should be possible to remove the ignition key from the lock. The key must be locked in position when the gear selector is in any position other than P.

Does the key lock function?

Yes - No Fault Found

No - Checking and replacing the component

-------------------------------------------------

Checking and replacing the component




- Expose the gear selector assembly according to Rear center console Rear Center Console
- Ignition on
- Brake pedal depressed.
Check that the lever in the gear selector assembly tensions the keylock cable when the button on the gear selector is pressed in. The lever must keep the cable tensioned when the gear shift selector is moved to positions other than P and the button is released.
Move the gear selector to position P. Release the button. Check that the tension in the cable is released. Remove the end of the cable from the lever. Pull the cable between the limit positions to check that the cable is not sticking or has come off.
Remedy as necessary.





Other information:
- To access or replace the keylock cable, see Replacing the key lock cable, AW55-50/51SN Removal and Replacement.

Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking the key lock

-------------------------------------------------