Removal and Replacement

Replacing the front turn signal lamps and side turn signal flashers

Turn signal lamps




Slacken off the screw holding the lamp two turns.
Hold in the catches. Pull the lamp housing forwards.
Disconnect the bulb holder.
Reinstall in reverse order.
Check the function.

Side turn signal flashers




The bulb and the bulb holder are replaced from the outside.
Remove the bulb holder by pressing off the retaining clip at the front edge as illustrated. Use a 0.3 mm feeler gauge.

Hint: Stick a piece of tape on the side of the feeler gauge. This is to prevent damage to the paintwork. Press the feeler gauge against the front fender.

Bulbs and holders




- Twist the lens until it detaches
- Disconnect the connector
- Replace the bulb or the holder.
Reinstall in reverse order.
- Check the function of the turn signal flasher.