Signal Too High. Intermittent Fault

Signal too high. Intermittent fault

Intermittent fault
Check the wiring between transmission control module (TCM) terminal #2 and terminal #3 on the 8-pin transmission connector. Check the wiring between control module terminal #30 and terminal #4 on the 8-pin transmission connector. Check for an intermittent short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.

Hint: Check solenoid SLT by measuring the resistance between terminals #3 and #4 on the transmission connector. The ohmmeter should read 5-5.6 ohms at 20°C.

Remedy as necessary.

Other information:
- To connect the breakout box, see Connecting the breakout box, AW55-50/51SN Connecting The Breakout Box
- To disconnect the transmission connectors, see Transmission connectors, AW55-50/51SN Transmission Connectors
- For information about signals, see Signal description. Transmission control module (TCM), AW55-50/51SN Signal Description.













Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

FAULT FOUND - DONE

Attempt New Test - Intermittent fault

-------------------------------------------------