Signal Too Low. Intermittent Fault

Signal too low. Intermittent fault

Checking the connector and cable












- Ignition off
- Disconnect the battery negative lead
- Disconnect the SRS control module and combined instrument panel connector B.
Check the control module terminal pins. Check for contact resistance and oxidation according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Check the cable between the combined instrument panel terminal #B11 and control module terminal #54 (#20). Check for an intermittent open-circuit according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults. Check for an intermittent short-circuit to ground according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Remedy as necessary.













Other information:
- To access and replace the control module see SRS control module Removal and Replacement
- To access and replace the combined instrument panel, see Driver information module (DIM), installation/removal, component replacement Removal and Replacement
- To connect the breakout box to the SRS, see Connecting the breakout box Connecting The Breakout Box

- For information about signals, see Signal specification Signal Description. Supplementary Restraint System (SRS).

Continue - Fault-tracing information
DONE

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

FAULT-TRACING FAILED - DONE

Attempt New Test - Checking the connector and cable

-------------------------------------------------