Signal Too High. Permanent Fault

Signal too high. Permanent fault

Checking the wiring and component




- Ignition off.
Check the voltage between ground and system relay base terminal #5. The voltage must be approximately 0 V when the system relay is disconnected.
If the voltage is above approximately 0 volts, check the cable at system relay base terminal #5. Check for a short-circuit to supply voltage according to Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.
Try a new system relay if no fault is found during the above fault-tracing.
Remedy as necessary.

Other information
- To connect the breakout box and access the control module, see Connecting the breakout box. EMS 2000 Connecting The Breakout Box. EMS 2000
- To access or replace the system relay, see Engine compartment Engine Compartment
- For information about signals see Signal specification Signal Specification.









Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.




- Reinstall the components, reconnect the connectors etc.
- Ignition on.
Activate the system relay. Check that the relay clicks and the fuel pump (FP) starts when it is activated.





Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - FAULT FOUND

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the wiring and component

-------------------------------------------------