Signal Too Low
Signal too low
Status check
Take resistance readings between the combined instrument panel connector terminal #B4 and ground.
Other information:
- For information about signals, see Signal specification Signal Specification, Driver Information Module (DIM)
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box, Driver Information Module (DIM).
Does the ohmmeter display a short-circuit?
Yes - Checking the wiring
No - Intermittent fault
-------------------------------------------------
Checking the wiring
Check the cable between combined instrument panel connector terminal #B4 (#4) and the radio connector terminal #B7. Check for a short-circuit to ground.
Other information:
- Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault
- For information about signals, see Signal specification Signal Specification, Driver Information Module (DIM)
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box, Driver Information Module (DIM).
Continue - Verification
-------------------------------------------------
Verification
Verification
Hint: After carrying out the repair, check that the fault has been remedied.
- Ignition off
- Connect the combined instrument panel to the car without the breakout box
- Raise the front wheels. Allow them to spin in gear at idling speed.
Measure the pulse signal on the radio connector terminal #B7.
Other information:
- For information about signals, see Signal specification Signal Specification, Driver Information Module (DIM)
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box, Driver Information Module (DIM).
Is there a signal?
Yes - VERIFIED
No - VERIFICATION FAILED
------------------------
VERIFIED - FAULT FOUND
VERIFICATION FAILED - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
Do you want to exit fault-tracing?
Yes - Exit fault-tracing
No - Attempt New Test
------------------------
Attempt New Test - Checking the wiring
-------------------------------------------------
Intermittent fault
Check the cable between combined instrument panel connector terminal #B4 (#4) and the radio connector terminal #B7. Check for a short-circuit to ground.
Other information:
- Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults
- For information about signals, see Signal specification Signal Specification, Driver Information Module (DIM)
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box, Driver Information Module (DIM).
Continue - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).
Do you want to view the information again?
Yes - Attempt New Test
No - FAULT FOUND
------------------------
Attempt New Test - Intermittent fault
FAULT FOUND - DONE
-------------------------------------------------