Signal Too High / Signal Too Low

Signal too high / Signal too low

Checking components and wiring

Diagnostic Trouble Code (DTC) CI-0C
Check the combined instrument panel and LPG control module connectors. Check for contact resistance and oxidation.
Check the signal cable between combined instrument panel terminal #B12 (#12) and LPG control module terminal #J1/04 (#4). Check for an open-circuit. Check for a short-circuit to supply voltage.

Diagnostic Trouble Code (DTC) CI-0D
Check the signal cable between combined instrument panel terminal #B12 (#12) and LPG control module terminal #J1/04 (#4). Check for a short-circuit to ground.
Remedy as necessary.

Other information:
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box, Driver Information Module (DIM)
- To connect the breakout box to the LPG control module, see
- For information about signals, see Signal specification Signal Specification, Driver Information Module (DIM)
- Checking wiring and terminals Checking Wiring And Terminals.













Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking components and wiring

-------------------------------------------------