Signal Missing. Intermittent Fault

Signal missing. Intermittent fault

Checking wiring and terminals
Check the control module connector and the fuse holder for fuse no. 12 (50 A) for contact resistance and oxidation according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Check the cable between control module connector terminal: 18 and the battery positive terminal (via fuse no. 12 (50 A)) for an open-circuit according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.













Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking wiring and terminals

-------------------------------------------------