Replacing the Boost Pressure Sensor 1

Replacing The Boost Pressure Sensor 1

Removal

Removing the fuel rail cover
- Remove the throttle body (TB) cover
- Remove the cover over the fuel rail.

Removing the intake manifold absolute pressure (MAP) sensor







- Disconnect the connector
- Slacken off the screw. Remove the cover.

Installation

Installing the intake manifold absolute pressure (MAP) sensor







- Replace the O-ring
- Position the sensor. Tighten the sensor. Tighten to 10 Nm
- Connect the connector.

Installing The Fuel Rail Cover
- Install and press the cover into place
- Install the throttle body (TB) cover.