Installing the Dashboard

Installing The Dashboard







NOTE:
- Before installation: Check that all components are correctly installed.
- Two people are required for this operation.

- Align the dashboard carefully.

Install:
- the upper screw by hand
- the screw for the passenger air bag module in the glove compartment
- the remaining screws.

Check the positioning of the dashboard.

Tighten the screw. Tighten to 12 Nm.

Connecting The Passenger Airbag Module







Connect the orange 4 pin connector for the passenger air bag module at the right-hand side of the center console.

Installing The Loudspeaker And Loudspeaker Grille On The Passenger Side







Install:
- the connector in the loudspeaker
- the loudspeaker in the dashboard.

NOTE: See the illustration for the location.

Install the rear edge of the loudspeaker grille and press the front edge into position.

NOTE: Start on the righthand side.

Installing The Dashboard Bracket And The Hood Catch







Install:
- the two connectors from the cable harness for the dashboard
- the blue and brown connectors from the dashboard cable harness
- the bracket and install the upper screw by hand
- the hood catch and the three screws. Tighten to 10 Nm
- the cable from the hood catch
- the cable harness clips in the dashboard
- the screw for the dashboard in the bracket (A)
- The central electronic module (CEM).

Installing The Loudspeaker And Loudspeaker Grille On The Driver's Side







Install:
- the connector in the loudspeaker
- the loudspeakers in the dashboard
- the loudspeaker grille.

Installing Components







Install:
- the combined instrument panel.
- the comfort control module.
- the radio panel.
- the front center console.
- the rear center console.
- the soundproofing panel.
- the upper A-post panel.

Final Check







NOTE: When all components have been reinstalled and secured, proceed as follows:

- First switch on the ignition
- Connect the battery negative terminal
- Check that the SRS warning light on the dashboard goes out.

WARNING: Ensure that nobody is in the car when the battery is being connected.

- Enter the radio code
- Set the clock.