Signal Too High. Intermittent Fault

Signal too high. Intermittent fault

Checking wiring and connectors




- Ignition off.
Check the cable between control module terminal #65 and rear heated oxygen sensor (HO2S) connector terminal #2. Check for an intermittent short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Remedy as necessary.

Other information
- To connect the breakout box and access the control module, see Connecting the breakout box. EMS 2000 Connecting The Breakout Box. EMS 2000
- To access or replace the rear heated oxygen sensor (HO2S), see Replacing lambda sond rear Removal and Replacement
- For information about signals see Signal specification Signal Specification.













Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking wiring and connectors

FAULT FOUND - DONE

-------------------------------------------------