Signal Missing

Signal missing

Status check
- Raise the car so that the wheels are accessible
- Start the engine and select a gear or rotate one of the front wheels by hand.

Note! If the car is equipped with anti-spin equipment, disengage it using the button.

Check that the speedometer is operating correctly.

Is the speedometer display incorrect?

Yes - Checking components and wiring

No - Checking components and wiring

-------------------------------------------------

Checking components and wiring
Check the ABS control module connector. Check for contact resistance and oxidation.
Check the signal cable between ABS control module terminal #14 and combined instrument panel terminal #B16 (#16). Check for a short-circuit to ground. Check for a short-circuit to supply voltage. Check for an open-circuit.
Remedy as necessary.

Other information:
- Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box, Driver Information Module (DIM)
- To access and replace the combined instrument panel, see Driver information module, removing/installing Removal and Replacement
- For information about signals, see Signal specification Signal Specification, Driver Information Module (DIM).













Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.




- Ignition off
- Reinstall the connectors, components etc.
- Test drive the car or rotate a front wheel.
Check that the speedometer is operating correctly.





Does the speedometer work? Is the value within its permitted range?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking components and wiring

-------------------------------------------------

Checking components and wiring
Check the ABS control module connector. Check for intermittent contact resistance and oxidation.
Check the signal cable between ABS control module terminal #14 and combined instrument panel terminal #B16 (#16). Check for an intermittent short-circuit to ground. Check for an intermittent short-circuit to supply voltage. Check for an intermittent open-circuit.
Remedy as necessary.

Other information:
- Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box, Driver Information Module (DIM)
- To access and replace the combined instrument panel, see Driver information module, removing/installing Removal and Replacement
- For information about signals, see Signal specification Signal Specification, Driver Information Module (DIM).













Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking components and wiring

FAULT FOUND - DONE

-------------------------------------------------