Fog Lamps

Fog lamps


















Fog lamps

Note! This accessory is connected to the car's electrical system. It requires software unique to the car

- Move the front seat to its rearmost position.




- Raise the car
- Cut out the embossed covers (1) on the left and right-hand side of the bumper.

Note! Cut around the outer (2) marking.

- Score around the marking
- Carefully cut through the material
- Remove the cover. Sand the edges if necessary.




- Remove the screw (1) from the air baffle (2) for the front brake
- Remove the air baffle. Pull it backward.




- Remove the screws (1). Slacken off the air baffle (2)
- Release the catches (3). Pull the air baffle backward
- Remove the air baffle.




- Install the spring nuts (1) in the holes.




- Install the fog lamp with the screws (1) from the kit.





Illustration 7A
- Take the cable harness from the kit. Connect the short cable (1) to the left-hand fog lamp. Connect the long cable to the right-hand fog lamp
- Press the cable into place in the two clamps (2)
- Connect the connector (3) to the pre-routed connector at the left-hand fender liner.





Illustration 7B
- Press the cable harness for the right-hand fog lamp into place under the air intake. Use the existing clamps (1).

- Reinstall the air baffles.




- Remove the cover (1) for the fuse holder
- Install a 15 A fuse in terminal 3 for model year 2000 cars. in terminal 18 for model year 01 cars-.
- Reinstall the cover.




- Remove the side panel (1). Slacken off the screw clip at the rear edge of the panel. Pull the panel outward / backward
- Remove the soundproofing panel (2). Carefully pry it loose. Use a weatherstrip tool or similar. The soundproofing panel is secured with three clips (3).




- Install the relay (1) from the kit in the relay holder socket marked MI11
- Reinstall the soundproofing panel and the side panel.




- Remove the cover (1) from the lighting control panel
- Install the light bulb (2)
- Install the button (3) from the kit. Press the button into place
- Program the software. See the service information in VIDA
- Check the function. Align the lamps.