Removal and Replacement

Throttle body (electronic throttle module, ETM), replacing

Replacing the electronic throttle module (ETM)




Disconnect the battery negative lead.
Remove the intake pipe between the front cover plate and the air cleaner (ACL).
Disconnect the intake manifold between the air cleaner (ACL) and the throttle body (TB) and put to one side.




Remove the throttle body (TB) and place it to one side.
Clean the gasket face.
Remove the starter motor and put to one side.
Disconnect the throttle body (TB) connector.

Installing the throttle body (electronic throttle module (ETM))





Install
- starter motor, tighten with 40 Nm against the transmission and 30 Nm for the bracket against the engine block
- the connector for the new throttle body (TB) with the cable on the outside of the starter motor bracket.
Secure the cable so that there is no risk of damage or a broken connection.





Install
- new throttle body with new gasket. Tighten with 10 Nm
- the intake manifold between the air cleaner (ACL) and the throttle body (TB) and the connected hoses
- the intake pipe between the front cover plate and the air cleaner (ACL)
- the cable to the battery negative terminal.

Ordering software
Order applicable software.






Finishing
Check that no diagnostic trouble codes have been stored during the repair.
Test drive the car and check that the engine function is OK.