Procedures

Turn signal lamps







- Slacken off the screw holding the lamp two turns.
- Hold in the catches. Pull the lamp housing forwards.
- Disconnect the bulb holder.
- Reinstall in reverse order.
- Check the function.

Side Turn Signal Flashers







- The bulb and the bulb holder are replaced from the outside.
- Remove the bulb holder by pressing off the retaining clip at the front edge as illustrated. Use a 0.3 mm feeler gauge.

HINT: Stick a piece of tape on the side of the feeler gauge. This is to prevent damage to the paintwork. Press the feeler gauge against the front fender.

Bulbs And Holders







- Twist the lens until it detaches
- Disconnect the connector
- Replace the bulb or the holder.

Reinstall in reverse order.

- Check the function of the turn signal flasher.